Wire Feeder

Wire Feeder | 74 MPa Plus | MR300577

Supplier: WeldConnect

Wire Feeder | 74 MPa Plus | MR300577

Miller S-74 MPa Plus Wire Feeder #300577 The Miller® S-74 MPa Plus single wire feeder is capable of synergic pulsed MIG Welding and can carry up to 4 separate welding programs easily retrieved for a faster setup.

Receive 1-3 days from order

This single wire feeder is also optimized for use with XMT™ MPa and Miller Invision™ MPa welders. It is also capable of operating with Miller push-pull aluminum MIG guns along with having adjustable weld sequence control. Capable of remote voltage control, the Miller® S-74 MPa Plus single wire feeder comes with a digital volt and wire feed speed meters (amp).

This heavy industrial, four drive roll, 24 VAC wire feeder for MIG and flux-cored welding wires feeds 0.23 to 5/64 diameter welding wire anywhere from 50-780 inches per minute. Coming standard with a trigger hold, dual tension control, adjustable run in and tool-less rotatable drive, the floating positive drive system provides consistent feeding of an array of welding wires.

Features of this product

Alumination™ technology gives you the ability to use the extended reach of a push-pull system for consistent, versatile and dependable aluminum wire feeding
Alumination gives you the versatility to handle whatever aluminum welding job you want to tackle Synergic Pulsed MIG operation when optimized with the Invision MPa power supplies
Provides communication between the power source, feeder and gun As wire speed increases/decreases, the pulse parameters also increase/decrease to match the right amount of power needed
Trigger schedule select allows the operator to select the alternative schedule by quickly tapping the gun trigger when not welding
When optimized with MPa power sources the operator can also switch from MIG to Pulsed MIGProfile Pulse™ provides TIG appearance with MIG simplicity and productivity
Achieve “stacked dime” weld bead appearance without back-stepping Profile Pulse frequency can be changed to increase or decrease the spacing between the ripple pattern to achieve the desired weld appearance
Accu-Mate™ properly seats the power pin for best feeding performance and prevents Accu-Mate grooved MIG guns from sliding in the cast

To contact WeldConnect about Wire Feeder | 74 MPa Plus | MR300577 use Get a quote.

Features of this product

Alumination™ technology gives you the ability to use the extended reach of a push-pull system for consistent, versatile and dependable aluminum wire feeding
Alumination gives you the versatility to handle whatever aluminum welding job you want to tackle Synergic Pulsed MIG operation when optimized with the Invision MPa power supplies
Provides communication between the power source, feeder and gun As wire speed increases/decreases, the pulse parameters also increase/decrease to match the right amount of power needed
Trigger schedule select allows the operator to select the alternative schedule by quickly tapping the gun trigger when not welding
When optimized with MPa power sources the operator can also switch from MIG to Pulsed MIGProfile Pulse™ provides TIG appearance with MIG simplicity and productivity
Achieve “stacked dime” weld bead appearance without back-stepping Profile Pulse frequency can be changed to increase or decrease the spacing between the ripple pattern to achieve the desired weld appearance
Accu-Mate™ properly seats the power pin for best feeding performance and prevents Accu-Mate grooved MIG guns from sliding in the cast

Read less...

To contact WeldConnect about Wire Feeder | 74 MPa Plus | MR300577 use Get a quote.