Single Phase True Power Controller | TE10P

TE10P from Invensys Eurotherm

By using either an analogue or digital set-point, the TE10P can be used for the precise control of power in loads that would otherwise prove difficult to accurately regulate.

Flexibility

The TE10P is configurable for different types of input, firing mode, feedback and load type. It is suitable for driving either simple resistive loads or complex loads such as Silicon Carbide, Platinum, Molybdenum or Short Wave Infrared lamps.

Dynamic load fault detection allows continuous monitoring of loads, including those with characteristics that are dependent on temperature or time.

The feedback type can be selected from; RMS Voltage, RMS Current, I2, V2, Transfer Between I2 and V2, transfer between I2 and Power, True Power or Open Loop.

Communications

Optional RS422 or RS485 communications with Modbus or Profibus protocol allow the TE10P to be configured or controlled from an external supervisory system.

Features

• Current range from 16 to 80 amps, voltage range from 100 to 500 volts
• Four digit display and single push button, simplify Operating, Commissioning, Maintenance and Configuration
• Isolated Analogue retransmission of power
• Configurable Alarm Relay

Click here for further product information

Read more...

To contact Invensys Eurotherm about Single Phase True Power Controller | TE10P use Get a quote.

By using either an analogue or digital set-point, the TE10P can be used for the precise control of power in loads that would otherwise prove difficult to accurately regulate.

Flexibility

The TE10P is configurable for different types of input, firing mode, feedback and load type. It is suitable for driving either simple resistive loads or complex loads such as Silicon Carbide, Platinum, Molybdenum or Short Wave Infrared lamps.

Dynamic load fault detection allows continuous monitoring of loads, including those with characteristics that are dependent on temperature or time.

The feedback type can be selected from; RMS Voltage, RMS Current, I2, V2, Transfer Between I2 and V2, transfer between I2 and Power, True Power or Open Loop.

Communications

Optional RS422 or RS485 communications with Modbus or Profibus protocol allow the TE10P to be configured or controlled from an external supervisory system.

Features

• Current range from 16 to 80 amps, voltage range from 100 to 500 volts
• Four digit display and single push button, simplify Operating, Commissioning, Maintenance and Configuration
• Isolated Analogue retransmission of power
• Configurable Alarm Relay

Click here for further product information

Read less...

To contact Invensys Eurotherm about Single Phase True Power Controller | TE10P use Get a quote.