Zenith - Clipboard Screws

Clipboard Screws

The head has ribs moulded around the countersunk head which help remove the chipboard particles when countersinking.

Countersunk Rib Head

Suitable for general fixing of chipboard, e.g., cabinets, furniture, kitchens, office partitioning etc. Available in 8 and 10 gauge. Lengths from 20mm to 100mm.

How to use Zenith Chipboard Screws:

• Measure the total thickness of the materials to be fastened;
• Choose a screw long enough to provide approximately 20mm of thread embedment into the chipboard or wood being fastened to;
• Fit a #2 Phillips drive bit to a power screwdriver set to to low speed, approximately 1000rpm;
• Put screw onto drive bit and place at fastening position;
• Push sharply on screwdriver to create a starting point;
• Drive screw home until the head is flush with surface.

To contact ITW Proline about Zenith Clipboard Screws use Get a quote.

The head has ribs moulded around the countersunk head which help remove the chipboard particles when countersinking.

Countersunk Rib Head

Suitable for general fixing of chipboard, e.g., cabinets, furniture, kitchens, office partitioning etc. Available in 8 and 10 gauge. Lengths from 20mm to 100mm.

How to use Zenith Chipboard Screws:

• Measure the total thickness of the materials to be fastened;
• Choose a screw long enough to provide approximately 20mm of thread embedment into the chipboard or wood being fastened to;
• Fit a #2 Phillips drive bit to a power screwdriver set to to low speed, approximately 1000rpm;
• Put screw onto drive bit and place at fastening position;
• Push sharply on screwdriver to create a starting point;
• Drive screw home until the head is flush with surface.

Read less...

To contact ITW Proline about Zenith Clipboard Screws use Get a quote.