Wire Cutter & Sculptor - 280H

Wire Cutter & Sculptor - 280H

A thin piece of resistance wire has a low voltage passed across it. This heats the wire. A piece of expanded thermoplastic material (normally polystyrene) is pushed onto the wire. The heat locally melts the material, collapsing the air pockets that it contains and allowing the wire to pass through. In this way the expanded material can be cut cleanly.

The Hot Wire Sculptor 280 incorporates:

• 280mm(11in) cutting length
• 635mm(25in) throat depth
• Adjustable work guides for accurate material referencing
• Robust polyethylene table
• Wire bow protractor accurately sets angles, chamfers & cones
• 5 cutting speeds
• 3 sculpting speeds
• Foot switch virtually eliminates fumes
• Extended bow (1,000 mm [39.5 in]) is available

 

To contact CR Clarke about Wire Cutter & Sculptor - 280H use Get A Quote.

A thin piece of resistance wire has a low voltage passed across it. This heats the wire. A piece of expanded thermoplastic material (normally polystyrene) is pushed onto the wire. The heat locally melts the material, collapsing the air pockets that it contains and allowing the wire to pass through. In this way the expanded material can be cut cleanly.

The Hot Wire Sculptor 280 incorporates:

• 280mm(11in) cutting length
• 635mm(25in) throat depth
• Adjustable work guides for accurate material referencing
• Robust polyethylene table
• Wire bow protractor accurately sets angles, chamfers & cones
• 5 cutting speeds
• 3 sculpting speeds
• Foot switch virtually eliminates fumes
• Extended bow (1,000 mm [39.5 in]) is available

 

Read less...

To contact CR Clarke about Wire Cutter & Sculptor - 280H use Get A Quote.