Schwartsmann - Pipe Cutters | SMA 80

Pipe Cutters | SMA 80

A further development of our proven motorized beading machine, type SMA 80, specially for cutting welded stainless steel pipes to length. It is powered by a pole changing motor (thermally protected) via V-belt and worm gear running in the oil bath. The optimal run-through speed can be selected from 4 different working speeds.Thanks to a massive base plate, the machine can be set up without any additional fixation.

The height of the top shaft is adjusted by means of the hydraulic driving power. Adjustable stops on the hydraulic cylinder limit the path of the top shaft. A cut with low contortion is guaranteed by supporting rings on the bottom shaft (behind the special cutter roller). 

The control takes place via a double foot switch. The machine is started by pressing the left foot switch, and the cutter roller mounted to the top shaft is lowered to the cutting position. After ending the cutting process, the right foot switch is pressed. The top shaft swivels back to the original position, and the machine driving power shuts down. 

Standard Accessories

• Special cutting wheels
• 2 large stop plates with additional one-sided preset pre-screwing plate for small or larger stop depths. 

 

To contact Sealumet about Schwartsmann Pipe Cutters | SMA 80 use Get a quote.

A further development of our proven motorized beading machine, type SMA 80, specially for cutting welded stainless steel pipes to length. It is powered by a pole changing motor (thermally protected) via V-belt and worm gear running in the oil bath. The optimal run-through speed can be selected from 4 different working speeds.Thanks to a massive base plate, the machine can be set up without any additional fixation.

The height of the top shaft is adjusted by means of the hydraulic driving power. Adjustable stops on the hydraulic cylinder limit the path of the top shaft. A cut with low contortion is guaranteed by supporting rings on the bottom shaft (behind the special cutter roller). 

The control takes place via a double foot switch. The machine is started by pressing the left foot switch, and the cutter roller mounted to the top shaft is lowered to the cutting position. After ending the cutting process, the right foot switch is pressed. The top shaft swivels back to the original position, and the machine driving power shuts down. 

Standard Accessories

• Special cutting wheels
• 2 large stop plates with additional one-sided preset pre-screwing plate for small or larger stop depths. 

 

Read less...

To contact Sealumet about Schwartsmann Pipe Cutters | SMA 80 use Get a quote.