L95-320 Vane Compressor

L95-320 Vane Compressor

Main applications include digester gas mixing, burners, gas engines, vapour recovery, aeration and crop spray.

The sliding blade design employed in these machines is an efficient and simple method of supplying medium volumes of air and gases at low pressure differentials. The once through lubrication system with isolated bearings makes these ideal for handling aggressive gases including Digester and Landfill.

The cylinder is made from high grade close grained cast iron with deep fins to provide ample cooling surface. The bore is machined to give maximum blade life. SG iron rotor and shaft assembly, balanced and accurately slotted. Sliding blades are made from a non-asbestos hard wearing resin bonded fabric material. Roller bearings are fitted to both ends and isolated from the cylinder.

Mechanical seals are fitted when handling aggressive gases to provide a positive seal. The blade depth can be quickly checked without removal of any parts or pipework. All machines in this range are aircooled with a fan fitted at the rear end to assist cooling. Overheating of vacuum pumps continuously working at 457 mm Hg (18”Hg) and above is eliminated by the introduction of cool filtered ballast air.

Normally supplied belt driven at speeds to give exact output requirements.

To contact Hurll Nu-Way about L95-320 Vane Compressor use Get a quote.

Main applications include digester gas mixing, burners, gas engines, vapour recovery, aeration and crop spray.

The sliding blade design employed in these machines is an efficient and simple method of supplying medium volumes of air and gases at low pressure differentials. The once through lubrication system with isolated bearings makes these ideal for handling aggressive gases including Digester and Landfill.

The cylinder is made from high grade close grained cast iron with deep fins to provide ample cooling surface. The bore is machined to give maximum blade life. SG iron rotor and shaft assembly, balanced and accurately slotted. Sliding blades are made from a non-asbestos hard wearing resin bonded fabric material. Roller bearings are fitted to both ends and isolated from the cylinder.

Mechanical seals are fitted when handling aggressive gases to provide a positive seal. The blade depth can be quickly checked without removal of any parts or pipework. All machines in this range are aircooled with a fan fitted at the rear end to assist cooling. Overheating of vacuum pumps continuously working at 457 mm Hg (18”Hg) and above is eliminated by the introduction of cool filtered ballast air.

Normally supplied belt driven at speeds to give exact output requirements.

Read less...

To contact Hurll Nu-Way about L95-320 Vane Compressor use Get a quote.