Cirlock - Lockout Devices for Circuit Breakers - System

Lockout Devices for Circuit Breakers - CIRLOCK® System

Available for most types of Circuit Breakers. Manufactured In Australia

The CIRLOCK ® lockout system basically consists of two parts.

• Lockout Arms
• Mounting Set

These must be ordered seperately and to fit type of C/B's.

For individually mounted Circuit Breakers 'Single' type Lockout Devices are available.

INSTALLATION: Permanent fixing is easily done with screws or rivets onto Circuit Breakers escutcheon plate. Mounting Sets prepares the hole board for lockouts. Install lockout Arms where needed, now or later.

The CIRLOCK System is a unique system of Lockout Devices for electrical circuit breakers that can, when properly installed and used, help to prevent unintended energization of electrical circuits.

The system consists of basically two parts:

• A MOUNTING SET to be attached to the circuit breakers escutcheon plate, normally in the full length of the cut-out made for C/B's.A slot and hole are then available for each 'pole' on the board -and
• a number of LOCKOUT ARM's, one for each circuit breaker, can be inserted in the slots in Mounting Sets during installation, or later.

Because various brands of circuit breakers have different pole widths and sizes, Mounting Sets and Lockout Arms must be ordered separately and to fit the brand and type of circuit breakers in use.

CIRLOCK System are standard manufactured mainly from Aluminium. Hole sizes for padlocks are 7mm.

Read more...

To contact Cirlock about Cirlock Lockout Devices for Circuit Breakers - System use Get a quote.

Available for most types of Circuit Breakers. Manufactured In Australia

The CIRLOCK ® lockout system basically consists of two parts.

• Lockout Arms
• Mounting Set

These must be ordered seperately and to fit type of C/B's.

For individually mounted Circuit Breakers 'Single' type Lockout Devices are available.

INSTALLATION: Permanent fixing is easily done with screws or rivets onto Circuit Breakers escutcheon plate. Mounting Sets prepares the hole board for lockouts. Install lockout Arms where needed, now or later.

The CIRLOCK System is a unique system of Lockout Devices for electrical circuit breakers that can, when properly installed and used, help to prevent unintended energization of electrical circuits.

The system consists of basically two parts:

• A MOUNTING SET to be attached to the circuit breakers escutcheon plate, normally in the full length of the cut-out made for C/B's.A slot and hole are then available for each 'pole' on the board -and
• a number of LOCKOUT ARM's, one for each circuit breaker, can be inserted in the slots in Mounting Sets during installation, or later.

Because various brands of circuit breakers have different pole widths and sizes, Mounting Sets and Lockout Arms must be ordered separately and to fit the brand and type of circuit breakers in use.

CIRLOCK System are standard manufactured mainly from Aluminium. Hole sizes for padlocks are 7mm.

Read less...

To contact Cirlock about Cirlock Lockout Devices for Circuit Breakers - System use Get a quote.