IQ640 Load Cell Surge Protector - By Instrotech Australia

IQ640 Load Cell Surge Protector - By Instrotech Australia

Featuring a unique triple stage surge protection circuitry the IQ640 handles higher transients than protectors based only on diodes. 

Stage 1 of the Surge Load Cell Surge Protector comprises 3-terminal gas discharge tubes providing superior differential and common mode protection against conducted transients than surge protectors based on 2-terminal gas discharge tubes.

 

Stage 2 of the Load Cell Surge Protector comprises current limiting fusible series surge resistors which in a rare case of extreme lightning or surge event will resort to a fail safe operation. This effectively disconnects the line from sensitive electronic equipment.

 

Stage 3 of the Load Cell Surge Protector comprises a low capacitance over voltage diode clamp array. The diode array clamps fast transients to a safe level until the gas discharge tubes turn on. 

• Protects against over voltage and high power impulse currents
• Protects signal, supply and shield lines
• High power triple stage surge protection
• Ground clamp provided on the exterior of the enclosure
• Suitable for AC or DC load cell excitation voltages
• IP65 environmental protection rating
• Supports 4 or 6 wire load cells
• Clear lid for easy fault finding
• Shielded 6-wire connection to the load cell instrumentation
• Cage clamp wire connectors
• 1 year limited warranty 

Load Cell Surge Protector Applications include:

• Cranes
• Load pins
• Load cells
• Tension cells
• Belt weighers
• Strain gauges
• Weigh bridges

Simple to install the IQ640 is installed between load cells or junction boxes and weighing amplifiers, the IQ640 may also be installed at both ends of the system for maximum surge protection. 

For more information on the Load Cell Surge Protector | IQ640 please call or use the IndustrySearch email for a direct reply.

Read more...

To contact Instrotech Australia about IQ640 Load Cell Surge Protector - By Instrotech Australia use Get a quote.

Featuring a unique triple stage surge protection circuitry the IQ640 handles higher transients than protectors based only on diodes. 

Stage 1 of the Surge Load Cell Surge Protector comprises 3-terminal gas discharge tubes providing superior differential and common mode protection against conducted transients than surge protectors based on 2-terminal gas discharge tubes.

 

Stage 2 of the Load Cell Surge Protector comprises current limiting fusible series surge resistors which in a rare case of extreme lightning or surge event will resort to a fail safe operation. This effectively disconnects the line from sensitive electronic equipment.

 

Stage 3 of the Load Cell Surge Protector comprises a low capacitance over voltage diode clamp array. The diode array clamps fast transients to a safe level until the gas discharge tubes turn on. 

• Protects against over voltage and high power impulse currents
• Protects signal, supply and shield lines
• High power triple stage surge protection
• Ground clamp provided on the exterior of the enclosure
• Suitable for AC or DC load cell excitation voltages
• IP65 environmental protection rating
• Supports 4 or 6 wire load cells
• Clear lid for easy fault finding
• Shielded 6-wire connection to the load cell instrumentation
• Cage clamp wire connectors
• 1 year limited warranty 

Load Cell Surge Protector Applications include:

• Cranes
• Load pins
• Load cells
• Tension cells
• Belt weighers
• Strain gauges
• Weigh bridges

Simple to install the IQ640 is installed between load cells or junction boxes and weighing amplifiers, the IQ640 may also be installed at both ends of the system for maximum surge protection. 

For more information on the Load Cell Surge Protector | IQ640 please call or use the IndustrySearch email for a direct reply.

Read less...

To contact Instrotech Australia about IQ640 Load Cell Surge Protector - By Instrotech Australia use Get a quote.